H&R lowering springs for Ford Transit Custom MK2 / V710

Choose from six H&R 28532 spring kits using the dropdown. Each kit is advertised at approximately 30mm front and 50mm rear lowering, with two front and two rear springs. These are different spring combinations, not six interchangeable versions of one kit.

Compare the part numbers

The table below summarises Octane’s catalogue. Wheelbase and seat count alone do not determine the correct kit: drivetrain, vehicle body type, axle loads and permanent carried weight must also be checked against the approval.

Why the kits differ

28532-1 and 28532-2 share the catalogue’s front spring but use different rear springs. 28532-3 and 28532-5 share a front spring and differ at the rear. 28532-4 uses another front spring specification. This is why a shared nominal lowering figure does not establish compatibility or suitability for a permanently laden van.

Do not choose by wheelbase or number of seats alone. Octane’s broad vehicle lookup can show several variants for the same engine. Tell us whether your van is diesel 2WD, diesel AWD or PHEV, and whether it is a panel van, double cab or passenger/camper conversion. Include your wheelbase, seating and any permanent equipment or carried weight. We will help confirm the exact H&R application.

Compatibility and exclusions

• Application-specific Transit Custom MK2 / V710 fitments.
• Not for MS-RT trim or bad-road suspension versions.
• Not for fully electric vehicles.
• PHEV suitability depends on the selected kit and approval; it is not a blanket exclusion or blanket approval for this range.

Price and contents

£484.85 including VAT per kit. This is 10% below Octane’s displayed £538.72 price, rounded to the nearest penny. Supplied as a spring set only: dampers, bushes and fasteners are not included.

Installation and technical documents

Final lowering depends on vehicle specification, existing suspension and load. Reduced clearance and changed ride comfort should be considered. Follow H&R’s instructions and check damper condition, bump stops, wheel clearance and axle loads. Professional installation and alignment are recommended.

• H&R Product information
• H&R Installation Manual
• H&R Part Type Approval (PTA)

Check the latest application document for the selected part. Contact RTECSHOP before ordering if your vehicle or load specification is unclear.

Additional Notes: All six variants £484.85 including VAT. Excludes MS-RT, bad-road suspension and full-electric models; application approval must be checked. - Choose H&R kit 28532-1 to 28532-6. Approx. 30mm front / 50mm rear lowering. Match drivetrain, wheelbase, seating and permanent load before ordering.